SAFETY DATA SHEET

SECTION 1: IDENTIFICATION

Product Name: 24K Pure Eco Gold
Other Means of Identification: Not applicable

Intended Use of the Product: Electroplating bath
Restrictions on Use: For professional use only

Name, Address, and Telephone of the Responsible Party
Manufacturer:
Gold Plating Services
378 North Main #112 Layton, UT 84041
T: (801) 546 6200
www.GoldPlating.com

Emergency Telephone Number
PERS (801) 629-0667 or (800) 633-8253 


SECTION 2: HAZARDS IDENTIFICATION

Classification of the Substance or Mixture 
Skin Corrosion/Irritation, Category 2
Eye Damage/Irritation, Category 2A

Label Elements
Hazard Pictograms:

Signal Word:
Warning 

Hazard Statements:
Causes skin irritation.
Causes serious eye irritation.

Precautionary Statements:
Wash hands thoroughly after handling.
Wear protective gloves, clothing, and eye and face protection.
If on skin: wash with plenty of soap and water.
If skin irritation occurs: get medical advice/attention.
If in eyes: rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing.
If eye irritation persists: get medical advice/attention.
Take off contaminated clothing and wash it before reuse.

Other Hazards
No data available 

Unknown Acute Toxicity
Not applicable


SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS

Mixture:

Chemical Name

CAS Number

EINECS Number

Concentration

Sodium sulfite

7757-83-7

231-821-4

4%

Sodium gold sulfite

19153-98-1

242-846-5

2.7%

The chemical identity and concentration of one or more ingredients of this product are withheld as a trade secret under the provisions of paragraph (i) of 29 CFR 1910.1200. This information will be made available to health professionals and others in accordance with the applicable provisions of this paragraph.


SECTION 4: FIRST AID MEASURES

Description of First Aid Measures
After Inhalation: Remove patient to fresh air. Support breathing if required. Obtain medical treatment for dizziness, unconsciousness, or irritation or difficulty in breathing.
After Skin Contact: Remove contaminated clothing and wash affected area thoroughly with soap and water. Launder clothing before re-wearing. Seek medical attention for prolonged skin irritation.
After Eye Contact: Flush with water, including under lids, for fifteen minutes. Obtain immediate medical attention.
After Ingestion: If patient is conscious, rinse mouth and drink at least two large glasses of water. DO NOT induce vomiting. Never give anything by mouth to an unconscious person. Obtain immediate medical attention.

Most Important Symptoms and Effects, Both Acute and Delayed
After Inhalation: Vapor and mist may cause irritation of nasal and respiratory passages.
After Skin Contact: May cause irritation. Prolonged contact may cause dermatitis.
After Eye Contact: Causes irritation, redness, and burning sensation.
After Ingestion: May cause irritation, nausea, vomiting, and diarrhea. Large amounts may cause systemic toxicity.
Chronic Symptoms: No data available 

Indication of Any Immediate Medical Attention and Special Treatment Needed
If exposed or concerned, get medical advice and attention. If you feel unwell, seek medical advice (show the label where possible).


SECTION 5: FIRE-FIGHTING MEASURES

Suitable Extinguishing Media
Use media appropriate for surrounding fire such as foam, extinguishing powder, carbon dioxide, or water spray. In case of fire, cool endangered containers with water spray.

Unsuitable Extinguishing Media
High pressure water jet.

Specific Hazards Arising From the Substance or Mixture
None

Advice for Firefighters
Precautionary Measures: Do not inhale combustion gasses.
Protection During Firefighting: For fires in enclosed areas, wear self-contained breathing apparatus and full protective gear.


SECTION 6: ACCIDENTAL RELEASE MEASURES

Personal Precautions, Protective Equipment, and Emergency Procedures
Wear appropriate skin, eye, and respiratory protection. Do not eat, drink, or smoke while cleaning up. Ensure adequate ventilation.

Environmental Precautions
Prevent spills and rinsings from entering storm or sanitary sewers or other waterways and contact with soil.

Methods and Material for Containment and Cleaning Up
Wear appropriate personal protective gear including eye, skin, and respiratory protection. Contain spilled material and collect by absorption or other suitable method. Flush spill area with water. Do not allow this material or its rinsings to enter storm or sanitary sewers or other waterways.


SECTION 7: HANDLING AND STORAGE

Precautions for Safe Handling
Avoid contact with eyes. Avoid prolonged repeated skin contact and breathing mists or vapors. Use in a well-ventilated area. Do not empty waste into sanitary drains.

Conditions for Safe Storage, Including Any Incompatibilities
Store in a cool, dry area. Use with adequate ventilation. Keep container tightly closed when not in use. Store only in the original container.


SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION

Exposure Limits
For substances listed in section 3 that are not listed here, there are no established exposure limits from the manufacturer, supplier, importer, or the appropriate advisory agency including: ACGIH (TLV), AIHA (WEEL), NIOSH (REL), or OSHA (PEL).

Appropriate Engineering Controls
Use in a well-ventilated area with local exhaust.

Personal Protective Equipment
Eye Protection: Chemical splash goggles or safety glasses with side shields must be worn.
Skin and Body Protection: Wear rubber or neoprene gloves. Wear rubber apron and long sleeves to prevent skin contact. Wash hands thoroughly with soap and water after handling and before eating or smoking.
Respiratory Protection: Wear appropriate, approved respiratory protection when ventilation is inadequate.


SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES

Physical State: Liquid
Color: Clear, colorless
Odor: None
Odor Threshold: Not available
Melting Point: Not determined
Freezing Point: Not determined
Boiling Point: 100 °C (212 °F)
Flammability (solid, gas): Not applicable
Upper/Lower Explosion Limits: Non-explosive
Flash Point: Not applicable
Auto-Ignition Temperature: Not applicable
Decomposition Temperature: Not available
pH: 8.5 – 10.5
Kinematic Viscosity: Similar to water
Solubility: Completely soluble in water at 20 °C
Partition Coefficient N-Octanol/Water: Not determined
Vapor Pressure: Not determined
Evaporation Rate: Not available
Relative Density(H2O = 1) @25 °C: 1.10 +/- 0.05
Relative Vapor Density: Not determined
Particle Characteristics: Not determined


SECTION 10: STABILITY AND REACTIVITY

Reactivity: Stable, non-reactive when stored and used according to
 recommendations.
Chemical Stability: No decomposition if used according to specifications.
Possibility of Hazardous Reactions: None are known
Conditions to Avoid: None reported
Incompatible Materials: Strong acids, bases, and oxidizers
Hazardous Decomposition Products: Sulfur oxides and metal oxide fumes


SECTION 11: TOXICOLOGICAL INFORMATION

Routes of Exposure and Symptoms
 Inhalation: Vapor and mist may cause irritation of nasal and respiratory passages.
Skin Contact: May cause irritation. Prolonged contact may cause dermatitis.
Eye Contact: Causes irritation, redness, and burning sensation.
Ingestion: May cause irritation, nausea, vomiting, and diarrhea. Large amounts may cause systemic toxicity.

Delayed and Immediate Effects & Chronic Effects from Short and Long Term Exposure
Reproductive Effects: No applicable information available.
Target Organ Effects: No applicable information available.

Acute Toxicity Estimates
Acute Oral Toxicity: LDLo: 2825 mg/kg (rabbit, sodium sulfite).
Acute Dermal Toxicity: No applicable information available.
Acute Inhalation Toxicity: No applicable information available.
Acute Eye Irritation: No applicable information available.
Dermal Irritation: No applicable information available.

Interactive Effects
No data available

Carcinogen Listings
IARC: No
NTP: No
OSHA: No


SECTION 12: ECOLOGICAL INFORMATION

Ecotoxicity
There are no data reported for this material; however, this product may be harmful to aquatic life.

Persistence and Degradability
There are no data reported for this material; however, this product may be harmful to aquatic life.

Bioaccumulative Potential
There is no evidence to suggest bioaccumulation will occur.

Mobility in Soil
 Accidental spillage may lead to penetration in the soil and groundwater. Improper handling and disposal of this material may cause environmental damage.

Other Adverse Effects
No data available 


SECTION 13: DISPOSAL CONSIDERATIONS

Disposal of this material is subject to user compliance with applicable laws and regulations and consideration of product characteristics at time of disposal.


SECTION 14: TRANSPORT INFORMATION

In Accordance with DOT, IMDG, and IATA / ICAO: Not regulated for transport.


SECTION 15: REGULATORY INFORMATION

Inventory Status
 All components are on TSCA, EINECS/ELINCS, AICS, and DSL.

US State Regulations
U.S. Superfund Amendments and Reauthorization Act (SARA) Title III:
SARA (311/312) HAZARD CATEGORIES

None

Immediate

Delayed

Fire

Reactive

Pressure Generating

X

X

  

SECTION 16: OTHER INFORMATION

Current SDS preparation date: October 28, 2024
Last SDS Preparation Date: January 15, 2022
Original SDS preparation date: December 15, 2015

Other Information
 This document has been prepared in accordance with the SDS requirements of the OSHA Hazard Communication Standard 29 CFR 1910.1200.

Disclaimer: To the best of our knowledge, the information contained herein is accurate. However, neither the above-named manufacturer/supplier nor any of its subsidiaries assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist.